Joint filling of tile linings

Floor and wall surfaces coated with ceramic tiles, clinker brick, glass and other mosaics

Apply JOINT FILLER 1-10 by impressing it diagonally into the joints using a rubber trowel or rubber smoothing trowel. When the film on the tile lining changes its colour, wash the lining using a soft sponge and water, wipe and polish it. Surfaces of rough or highly absorbing tiles are more difficult to clean, therefore, in general and especially in such cases, test the cleaning procedure on a test tile prior to application of a joint filler. When removing the film applied to tile surface, diluted acetic acid or special cleaning agents may be used to remove cement stains.

This joint filler contains quarz sand, which can damage tile surface in exceptional cases; therefore, use a test tile to check resistance of its surface against scratching!                           

to fill a m² of tile lining, you will need ~0.5 to 1 kilo of JOINT FILLER 1 - 10
depending on width and depth of joints and the tile size.