All types of surfaces, which have been levelled with JUBOLIN, JUBOLIN P-25, NIVELIN or similar levelling compounds prior to painting

Painted surfaces should be resistant only to dry scrubbing

1. PAINTING WITH PAINTINGS, WHICH BELONG TO THE JUPOL FAMILY AND ARE RESISTANT TO DRY SCRUBBING

Paints from the JUPOL family, which are resistant to dry scrubbing, are mainly white. Tinting is limited and possible only to light pastel shades. Their application is not demanding, stains can be removed easily using a wet cloth.   

a) primer:
Not necessary!

b) painting
solution A                                                                                                                
painting with JUPOL (for wall and ceiling surfaces, where no special treatment is envisaged, at least demanding and the most common way of painting)                      
Paint is applied onto a dry primer using a long-bristle painting roller, a brush or it can be sprayed in two (if necessary, in three) coats (it is diluted with up to 10% of water and up to 15% of water on extremely absorbing surfaces; tinting is possible on JUMIX tinting stations; on a construction site it is tinted with UNITON, DIPI COLOR or DIPI CONCENTRATE).

to paint a m² of a normally absorbing and very rough surface (a two-coat  application), you will need ~190 ml of JUPOL.

solution B                                                                                                                  
painting with JUPOL CITRO (there appears pleasant smell of lemon in freshly painted rooms; this paint successfully hinders development of wall mould)                   
   
Paint is applied onto a dry primer using a long-bristle painting roller, a brush or it can be sprayed in two (if necessary, in three) coats (it is diluted with up to 10% of water and up to 15% of water on extremely absorbing surfaces; tinting is possible on JUMIX tinting stations; on a construction site it is tinted with UNITON, DIPI COLOR or DIPI CONCENTRATE).

to paint a m² of a normally absorbing and very rough surface (a two-coat application), you will need ~190 ml of JUPOL CITRO.

solution C                                                                                       
painting with a highly-covering interior wall paint JUPOL CONCENTRAT (only white, tinting is not possible).
                                                                                              
Do not stir, tint and dilute this paint. It is applied in two coats using a short-bristle fur or textile painting roller (length of hairs or threads is approximately 10 mm). Scoop the paint with a roller directly from the original container, do not use a bucket grid.

to paint a m² of a normally absorbing and very rough surface (a two-coat application), you will need ~250 ml of JUPOL KONCENTRAT.

2. PAINTING WITH A BIO LIME INTERIOR PAINT

solution D                                                                                                                       
painting with a BIO LIME INTERIOR PAINT (only white, since tinting is very
demanding and is thus dissuaded; this paint operates as a disinfectant and relatively successfully hinders development of wall mould; stains cannot be removed from furniture and other surfaces). 

a) a primer:
Not necessary!


b) painting:
Then, apply the paint onto a dry primer using a long-bristle painting roller, a brush or spray it in two (if necessary, in three) coats (dilute it with maximum 10% of water).

for a primer and to paint a m² of normally absorbing and very rough plastered surface (a two-coat application), you will need ~200 ml of BIO LIME INTERIOR PAINT.


.