Decorative renders

MINERAL SMOOTH RENDER 1.5 and 2.5

• typical evenly grained appearance
• two granulations: 1.5 and 2.5 mm
• one-component, natural white
• application to all kinds of fine plastered substrates including that of facade thermal insulating systems is possible (regardless of the type of insulating lining)
• highly water-vapour permeableworse water repellence, therefore, it is suitable only for buildings up to two floors high having projecting roofs of proper width
• application in less favourable weather conditions (low temperatures, high atmospheric humidity) is not possible (spots)

 Coat the substrate with diluted white ACRYLCOLOR first (ACRYLCOLOR : water = 1 : 1). Apply mortar compound in thickness slightly above the diameter of the largest sand grain manually (using a stainless steel smoothing trowel) or using a machine (by spraying) onto a dry pre-coat. Smooth the compound by circular movements using a plastic smoothing trowel until an evenly grained surface is achieved.

The joining of surfaces in corner edges is facilitated by installing finely smoothed stripes which have got a width of only a few centimetres. Such stripes are recommended also when dividing big façade boards to several smaller ones to avoid any trouble at application of the render and unaesthetic appearance due to a surface, which may not be even enough, and, at the same time, by applying the stripes interesting decorative effects can be achieved.

Painting of the render is possible a week after application.

To process a m² of the surface, you will need ~70 ml of white ACRYLCOLOR and ~2.6 kg of MINERAL SMOOTH RENDER 1.5 or 3.6 kg of MINERAL SMOOTH RENDER 2.0.Back