Decorative spray renders

MINEROL

• typical evenly grained appearance
• natural white
• can be applied either manually (by a splatter gun) or by a machine (spray gun)
• possible to apply onto all types of fine plastered substrates including all types of façade thermal insulating systems
• worse water repellence, therefore, it is suitable only for buildings up to two floors high having projecting roofs of proper width
• application in less favourable weather conditions (low temperatures, high atmospheric humidity) is not possible (spots)

MINEROL is applied in at least three coats. Dilute mortar compound with up to 10% of water prior to the application of the first coat, when the entire substrate has to be covered with a pre-coat and especially when it is applied to extremely absorbing substrates. Spraying in a coat that is too thick results in an unsuitably put on/installed and usually also cracked surface, therefore, reduce thickness and increase the number of coats especially in case of less-absorbing substrates. Spray the first coat of the render by moving the spray gun or splatter gun left – right, in a horizontal direction, the next coat by moving the gun up – down in a vertical direction and so on. When applying the last coat, you can circle with the gun over the treated surface to achieve the structure of as even appearance as possible. Mortar compound can be applied in this way also in case of the first two coats.

The joining of surfaces in corner edges is facilitated by installing finely smoothed stripes which have got a width of only a few centimetres. Such stripes are recommended also when dividing big façade boards to several smaller ones to avoid any trouble at application of the render and unaesthetic appearance due to a surface, which may not be even enough, and, at the same time, by applying the stripes interesting decorative effects can be achieved.

Painting of the render is possible a week after application.

To process a m² of the surface, you will need ~3.5-4 kg of MINEROL.